|
Fixed Competence Centre Work item form |
R&TTE Directive |
ITAAB - Advisory Notes048_r2.doc "Handling of glitches when performing tests B.2.4 and B.2.6.1 of TBR 3"053_r2.doc "TTCN description of preamble PRE_F3_CP" 054_r4.doc "Additional French attachment requirements for ISDN"054_ra4.doc "Additional requirements and tests for attachment to the France Telecom ISDN Network, Euro-NUMERIS" 054_rb4.doc "Requirement Table for Additional requirements for attachment to the France Telecom ISDN Network, Euro-NUMERIS"054_rc4.doc "Information about some of the differences in the Euro-NUMERIS Network not imposing special attachment requirements" 055_r1.doc "Value of the state used in STATUS message"060_r2.doc "Testing to be performed for Basic Access layer 1, including variations of Power Sources to be applied during testing of Electrical Characteristics" 060_ra2.doc "List of ISDN L1 Basic Access Tests and test case selection criteria"061_r2.doc "Problem with performing the electrical characteristics tests at Basic Access Layer 1 for TEs with an unstable state F3" 063_r4.doc "Output jitter test of TBR 12 and TBR 13"066_r3.doc "Test case selection to be performed for Basic Access and for Primary Rate Access for layers 2 and 3" 066_ra3.doc "List of tests and Test Case Selection Criteria for ISDN Layer 2 Basic Access and Primary Rate Access"066_rb3.doc "List of tests and Test Case Selection Criteria for ISDN Layer 3 Basic Access and Primary Rate Access" 067_r1.doc "Testing to be performed for Primary Rate Access layer 1"067_ra1.doc "List of ISDN L1 Primary Rate Access Tests and Test Case Selection Criteria" 068_r1.doc "CRC processing and generation of CRC error reports: Monitoring contiguous E-bits"069_r1.doc "Basic Access Layer 1 tests with problems for Unstable state S4 at Layer 2" 070_r1.doc "CRC processing Test Procedure Change"071_r1.doc "Requirements to EURO-ISDN basic access terminal equipment capable of handling only incoming or only outgoing calls" 071_ra1.doc "TBR-RT for EURO-ISDN basic access terminal equipment capable of handling only incoming or only outgoing calls"072_r1.doc "Requirements to EURO-ISDN primary rate access terminal equipment capable of handling only incoming or only outgoing calls" 072_ra1.doc "TBR-RT applicable to EURO-ISDN primary rate access terminal equipment capable of handling only incoming or only outgoing calls"075_r1.doc "Approval of TE's capable of automatic inter-working between equipment with and without CRC-4 capability" 076_r1.doc "Problem with performing the functional characteristics tests at Basic Access Layer 1 for TEs with an unstable state F3"080r1.doc "Use of preferred/exclusive bit in the RESTART ACK PDU in TC19003" 082_r1.doc "Connection of the simulator to the IUT"083_r1.doc "Layer 3 default DF69901" 084_r1.doc "Layer 3 response time in Primary Rate Access layer 2 tests"085_r1.doc "Information element checking layer 3 TC20002" 086_r1.doc "Layer 2 test case TC27031"087.doc "Handling of IUT's supporting En-bloc sending without using the Sending Complete IE, or supporting more than one dialing mode" 088_r1.doc "Postamble CHECK_F1"090.doc "Testing for X.21 circuits" 091.doc "Data Rates for testing"092.doc "TE with X.21 or X.21bis interfaces with one or more configurations which do not support X.25" 094.doc "Timer TWAIT in the So Layer 1 Test suite"095.doc "Test description for Receiver effective shunt capacitance for CCITT V.28 interchange circuits (7.5.2.1)" 096.doc "Categorizing of ISDN Terminals based on the possible physical configuration/operation and data link operation"097.doc "Power Source 1 voltage to be supplied to a TE during testing" 098.doc "System states for power feeding tests"101_r1.doc "Clarification on measurements on TEs with volume control" 102.doc "Power consumption of Terminal Equipments"103.doc "Information element checking in TBR 33/34 layer 3 TC20002" 104.doc "Test case selection to be performed for Basic Access for CTR 33 layers 2 and 3"104_a.doc "List of tests and Test Case Selection Criteria for Packet Mode ISDN Layer 2 Basic Access" 104_b.doc "List of tests and Test Case Selection Criteria for Packet Mode ISDN Layer 3 Basic Access"105.doc "Test method for TBR 4 Clause B.3.2 - Immunity to attenuation and reflections" 106.doc "Correction of editorial error in TBR 33 layer 3 TC11101"107.doc "CRC processing Test Procedure Change" 110.doc "Incidental non-compliances and unexpected PDUs"111.doc "Alternative means of connection for attachment to V-series interfaces" 113_r1.doc "Errors in the Requirements table in Annex A of TBR 33"113_ra1.doc "TBR Requirement Table (TBR-RT) for TBR 33" 114.doc "Clarification of the term "Mains Powered", used in TBR-RT's for selection of Protection tests"115.doc "Correction of editorial error in subclause 5.7.3 of ETS 300 047-3" 116.doc "Definition of timers T_APPLI1 and T_APPLI2"118.doc "Error in TBR 3 test cases TIF4 info2 and TIF4 info4" 119_r1.doc "Overvoltage Protection"119_ra1.doc "Overvoltage Protection Tests from ETS 300 046-3" 119_rb1.doc "Overvoltage Protection Tests from ETS 300 047-3"120.doc "TBR3 Test Cases TIF7COMPDEACT1 AND TIF8COMPDEACT1" 121.doc "Error in the layer 2 Test Case Selection Expression Definition in TBR 33"122.doc "Errors in layer 3 PDU Constraint Declarations in TBR 33 and TBR 34" 123.doc "Problems in layer 2 preambles for terminal equipment unstable in state 4"124.doc "Use of Circuit Mode layer 1 test results for CTR 33 and CTR 34 approval respectively" 125.doc "Correction of test case references"126.doc "Power consumption of locally powered TE which draw power from the basic rate interface"
|
|
|
Last updated: 2007-03-19 14:38:37 |
|